乐发II5001. It is suitable for medical places such as hospitals, nursing homes and rehabilitation centers, and assistants to walk and protect the wall.

乐发II5002, the panel is PVC, lined with aluminum alloy, and the accessories are ABS.

3. The hand part of the anti collision handrail conforms to the requirements of the body mechanics, and has a comfortable and reasonable circular arc in hand.

4, the panel material is high polymer PVC, fine and compact particles, the surface special treatment with anti scraping coating;

5, the surface surface of the panel has anti slippery fine lines and antifouling treatment. It is not easy to change color and is easy to clean.

乐发II5006, the panel has weatherability, flame retardancy and antibacterial property.

7, the overall color of the anti-collision armrest meets the requirements of the hospital, with uniform color and no obvious color difference.

乐发II5008. The aluminum alloy parts are required to squeeze out the original high quality aluminum ingot and meet the support and collision avoidance.

Anti-collision armrest accessories: aluminum alloy, hard PVC cover, anti-collision strip, elbow, bracket, expansion bolt, elbow fixed screw.

1, the necessary tools for installing armrest: aluminum alloy cutting machine, percussion drill (matching M12 bit), electric drill (with M6 bit), grinding machine, 10 and 14 socket wrench, artistic knife, tape, scissors, pencil, marker pen, hammer and so on.

乐发II500Chongqing handrails factory

乐发II5002, the height of installation, the general handrail installed to the top of the wall is 90 centimeters from the ground.

3. Take the length and take the wall of the armrest from the left to the right.

4, after cutting the aluminum alloy for a long time, the length of the aluminum alloy is (the total length minus the length of the elbow 16 centimeters (one elbow 8 centimeters) minus the distance between the two sides. The distance is 1-2 centimeters.

乐发II5005, (drilling support hole position) from the ground to take a vertical height of 83 centimeters to make a mark hole, embedded in the expansion screw, the distance between the right and left according to the actual situation.

6, (loading elbow) to the right and left elbow on the aluminum alloy, do a good mark hole fixed elbow!

乐发II5007, (aluminum alloy) put the two aluminum alloy on the wall with expansion screws, adjust the distance between left and right, and drill holes on the aluminum alloy center line corresponding to the expansion screw position.

乐发II5008. Install the fixed aluminum alloy (with one side of the collision bar down), install the collision bar

9, (with cover) using tape from left to right elbow elbow distance, with a cutting machine cut measured size (surface cover, the best cutting 1mm) cover buckle in Aluminum Alloy, wipe clean surface cover, installed!